iDirect Evolution X1, Инструкция по установке и безопасности

Страница: 27 / 60

iDirect Evolution X1 Satellite Router Installation and Safety Manual 15
Unpacking iDirect Evolution X1 Satellite Router Equipment
4.2 Unpacking iDirect Evolution X1 Satellite Router
Equipment
The Evolution X1 Satellite Router may be shipped in one or more shipping containers,
depending on the type of bundle purchased. Once you have received all of the boxes, perform
the following tasks:
•
Ensure the boxes are facing upward. (Refer to the box orientation arrows on the shipping
container.)
• Inspect all shipping containers. If any damage or other signs of mishandling are evident,
inform the carrier and either iDirect or the reseller.
• Remove the tape and any exterior covering from the box lid.
Note: Save the iDirect Evolution X1 Satellite Router shipping boxes after you have
unpacked the system. You will need these boxes if you want to move or ship the
system in the future.
Remove items from the box only as needed. Verify that you have received all of the proper
Evolution X1 Satellite Router components and accessory items listed in your order, including
the optional equipment you ordered.
4.3 Components Typically Included in an Order
Prior to installation, ensure that you have received all of the necessary components for a
complete VSAT installation. If any items are missing or damaged, please contact your Network
Operator/Distributor for replacement.
A typical installation includes:
•
An iDirect Evolution X1 Satellite Router
• +24 VDC power supply
• One high speed Ethernet LAN cable
• An antenna ranging in size from 0.75m, 0.96m, 1.2m, 1.8m, or 2.4m for Ku-Band; and
1.8m, 2.4m, and 3.8m for C-Band
• An IFL cable
• An appropriate feed assembly for the antenna (OMT)
• A Block Up Converter (BUC); 1.5W or 3W for Ku-Band and C-Band
• Low Noise Block converter (LNB)
4.3.1 Additional Components Normally Required
• An iDirect Specified L-Band cable — Consists of a RG-6 or RG-11 dual-coax cable and
connectors (to connect the IDU and ODU), plus type F connectors and sealant tape. (See
Chapter 4, Installation .)
• Non-Pen (Non-Penetrating) Roof Mount
• Ballast (anchor weight)
A picture of a typical antenna with BUC and LNB is shown in Figure 3 .