iDirect Evolution X1, Инструкция по установке и безопасности

Страница: 23 / 60

iDirect Evolution X1 Satellite Router Installation and Safety Manual 11
RF Specifications
3.3 RF Specifications
The iDirect Evolution X1 Satellite Router RF specifications are presented in Table 5 .
DC Power F-Connector BUC Power (IFL) +24 VDC, 20W max (up to 50

C), up to 3W BUCs
65W external PSU are supported LNB Power (IFL) +24 VDC 170mA
(DiSEqC) 22 kHz DiSEqC tone
NOTE: Only use the iDirect approved and provided power
supply (Part number P0002253-0001).
Protection • Internal, primary current fuse, inside power supply
• Over current protection
• Short circuit protection
Power Factor Correction Complies with EN61000-3-2 and EN61000-3-3
Efficiency 87% minimum
Input Transient Response 0 msec for 0% to 100% load change typical
AC Input Connector IEC-320-C6
AC Power Cord 18 AWG, country dependent
Table 4. Power Specifications (continued)
Category Description
Table 5. RF Specifications
Category Description
Frequency Range
Transmit:
Receive:
950-1700 MHz
950-2150 MHz
Frequency Tuning Step Size
Transmit:
Receive:
0.6 Hz
Sub-Hertz with Demodulator
RF Power Range
Transmit:
Receive:
-30 dBm to 0 dBm
Single Carrier Input Power:
Minimum: -130 +10Log
10
(Symbol Rate) dBm to - 5 dBm
Pmax = 0 dBm minimum, 30 dB attenuation adjustable in 1 dB
steps
Composite Wideband Input Power: -5 dBm (maximum)
RF Power Adjustability
Transmit:
Receive:
1.0 dB Nominal Step Size
Under AGC for all valid Rx input power range