51
Press ENTER to accept the Current Setpoint. The cursor will blink on the bottom line indicating that the Flow
setpoint may be adjusted.
12.
Press the UP and/or DOWN arrow keys to adjust the Max Flow setpoint.
M A X S E T P T 2 0 . 0 M A
F L O W : 5 . 9 2 G P M
You may back out of the DRY calibration routine at any point up to now without saving any
calibration settings by pressing the MENU key several times.
Press the ENTER key to save the new Analog Calibration values. Upon completion of Calibration you should see the
following screen.
A N A L O G I N P U T
C A L I B R A T E D
13.
Press the MENU key several times to return to Operation Mode.
8.1.4
Analog Output Calibration
The analog output calibration routine maps the motor speed as % of maximum motor speed configured in
Section 6.5
Flow Display and Units
The MPC VECTOR will display calibrated pump flow in GPH, LPH, GPM, or LPM on the digital display
when configured for flow control. The motor speed (in RPM) may also be viewed while in flow control.
Changes to the flow units are made in the Menu
-
>
System Setup-> Flow Units
Menu. See
Section 16 Menu
Maps
for assistance.
Setting Max Flow and Max Speed
of the MPC VECTOR to a 4-20mA output signal. The output signal is NOT
proportional to pump flow. If a 4-20mA signal representing flow is required it must be obtained by splitting the flow
meter output signal.
MO
T
O
R PERCENT
S
PEED
Figure 8-6 Analog Output Scaling/Calibration Curve
1.
The starting display will be:
S E T P T
X X . X X X
F L O W X X . X X X
2.
Press the MENU key
- M E N U -
Содержание Pulsafeeder MPC Vector
