![background image](http://html1.mh-extra.com/html/idex/pulsafeeder-mpc-vector/pulsafeeder-mpc-vector_installation-operation-and-maintenance-manual_3700937010.webp)
4
Menu
Press to adjust controller settings, to exit the menu system,
to move cursor back when entering values, or to step back to
higher level menus
Enter
Press to accept changes in menus, to move cursor forward
when entering values, and to access lower level menus.
Arrow Up
Press to increase value, and to scroll up through menu
options
Arrow Down
Press to decrease value, and to scroll down through menu
options
Lamp
Color
Description
Off, Green,
Red
Off = Motor off Green = Motor on
Red (blinking) = System Error
Green, Off
Green = Manual (Local) Control
Off = Automatic (Remote) Control
Table 1-2
– Keypad and Lamp Operation
1.2.3 System
Modes
The MPC VECTOR operates at two system level modes, normal system control mode and system configuration
mode. Normal system control mode allows the user to change flow rates or motor RPM in order to adjust
process flow conditions to suit their needs. System Configuration mode allows the user to setup the controller
for various user applications, thus customizing the pump rate controller for a particular process.
1.2.3.1 System
Configuration Mode
System configuration mode allows the user to set up the pump controller for the particular customer
application. The configuration mode has 4 major categories for the user to setup their pump application. Most
configurations must be done in the pump off state.
Shown below are the major configuration categories and the sub categories within each configuration area.
Configuration
Menu
Sub Menu
Description
Calibration
Pump Flow
Pump flow calibration for open and closed loop flow setups. 2
point calibration
Analog Input
Allows 4-20 mA signal calibration for speed control in sensorless
vector speed control and flow in closed loop control.
Analog Output
Provides 4-20 mA output calibration of current output vs. speed in
sensorless vector mode and flow in closed loop mode
Motor
Provides motor nameplate data entry and calibration of the chosen
MANUAL
ON
Содержание Pulsafeeder MPC Vector
