IDEC MICROSmart FC5A Series, Руководство пользователя

Страница: 167 / 343

13: P
ULSE
I
NSTRUCTIONS
FC5A M
ICRO
S
MART
U
SER
’
S
M
ANUAL
FC9Y ‐ B1273 13 ‐ 21
Timing Chart for Reversible Control with Single Pulse Output
This program demonstrates a timing chart of the RAMP1 instruction when reversible control is enabled with single pulse
output.
D1
M50
I0
RAMP
1 S1
D200
D204 = 1 (reversible control with single pulse output)
• When input I0 is turned on, RAMP1 generates output pulses starting at the initial frequency designated by the value stored
in data register D202. While the output pulses are sent out from output Q0, internal relay M50 remains on.
• Operation modes 0 through 2: The pulse frequency increases according to the frequency change rate value stored in data
register D203.
• Operation mode 3: The pulse frequency increases as long as the frequency change time stored in data register D203.
• While the output pulse frequency is on the increase, internal relay M52 remains on.
• Depending on the control direction designated by the value stored in data register D205, control direction output Q1 turns
off or on while D205 stores 0 (forward) or 1 (reverse), respectively.
• When the output pulse frequency reaches the steady pulse frequency designated by the value stored in data register D201,
internal relay M52 turns off. When the output pulse frequency starts to decrease, internal relay M52 turns on again.
• When the quantity of generated output pulses reaches the preset value designated by data registers D206 and D207, RAMP1
stops generating output pulses. Then internal relay M50 and M52 turn off, and internal relay M51 turns on.
• If the parameter values in D200 through D207 (except for D204) are changed while generating output pulses, the change
takes effect when start input I0 is turned on for the next cycle.
• If the value stored in D204 is changed after start input I0 has been turned on, the change can take effect only after the CPU
starts again.
• If start input I0 is turned off before reaching the preset value, RAMP1 stops generating output pulses immediately, then
internal relay M50 turns off and internal relay M51 turns on. When input I0 is turned on again, RAMP1 restarts to generate
output pulses for another cycle, starting at the initial pulse frequency.
Pulse Output Status M52
Output Pulse Q0
Start Input I0
Control Direction Output Q1
Pulse Output Complete M51
Initial Pulse Frequency
Steady Pulse Frequency
Control Direction D205 0 (Forward) 1 (Reverse)
Pulse Output ON M50