IDEC MICROSmart FC5A Series, Руководство пользователя

Страница: 126 / 343

11: P
ROGRAM
B
RANCHING
I
NSTRUCTIONS
11 ‐ 2 FC5A M
ICRO
S
MART
U
SER
’
S
M
ANUAL
FC9Y ‐ B1273
Example: LJMP and LABEL
The following example demonstrates a program to jump to three different portions of program depending on the input.
Using the Timer Instruction with Program Branching
When the timer start input of the TML, TIM, TMH or TMS instruction is already on, timedown begins immediately at the
location jumped to, starting with the timer current value. When using a program branch, it is important to make sure that
timers are initialized when desired, after the jump. If it is necessary to initialize the timer instruction (set to the preset
value) after the jump, the timer’s start input should be kept off for one or more scan cycles before initialization. Other ‐
wise, the timer input on will not be recognized.
Using the SOTU/SOTD Instructions with Program Branching
Check that pulse inputs of counters and shift registers, and input of single outputs (SOTU and SOTD) are maintained dur ‐
ing the jump, if required. Hold the input off for one or more scan cycles after the jump for the rising or falling edge transi ‐
tion to be recognized.
When input I0 is on, program execution jumps to label 0.
When input I1 is on, program execution jumps to label 1.
When input I2 is on, program execution jumps to label 2.
M8121 is the 1 ‐ sec clock special internal relay.
When jump occurs to label 0, output Q0 oscillates in 1 ‐ sec increments.
M8122 is the 100 ‐ ms clock special internal relay.
When jump occurs to label 1, output Q1 oscillates in 100 ‐ ms increments.
M8123 is the 10 ‐ ms clock special internal relay.
When jump occurs to label 2, output Q2 oscillates in 10 ‐ ms increments.
LABEL
0
I0
LJMP S1
0
END
I1
LJMP S1
1
I2
LJMP S1
2
M8121
END
M8122
END
M8123
END
Q0
Q1
Q2
LABEL
1
LABEL
2
I1
SOTU
M0
LJMP S1
0
Although normally, the SOTU instruction produces a pulse
for one scan, when used in a program branch the SOTU
pulse will last only until the next time the same SOTU
instruction is executed.
In the example on the left, the program branch will loop
as long as internal relay M0 remains on. However, the
SOTU produces a pulse output only during the first loop.
Q1 Internal
ON
OFF
Q1 Output
ON
OFF
Memory
END END
Q1
LABEL
0
Since the END instruction is not executed as long as M0 remains on, output Q1 is not turned on even if input I1 is on.