IDEAL INDUSTRIES SignalTEK II, Руководство пользователя

Страница: 23 / 58

SignalTEK II 156810 Iss 1
User Guide Page 23
Tone
Fig 33
SignalTEK II can act as a tone generator (Fig 33). Together with a compatible
tone probe, the route of a cable can be traced. A choice of three tones can be
selected. To achieve the best result, the tone may be played over one of eight
pins relative to the other seven, or over one of four pairs. The tone is started
and stopped with the F1 soft key which displays as RUN or STOP accordingly.
Press the soft key SETUP (F3) to change the tone and the pin, or pin pair, that
the tone is played on. Press the soft key APPLY (F2) for your changes to take
effect.
Autotest
Fig 34
SignalTEK II can be set up to run a predefined
range of tests when the yellow Autotest button is
pressed on either the Near-End or Remote Unit.
The
range of tests is set from
SETUP>TESTS>AUTOTEST by ticking the check
boxes next to your choice, Fig 34. Press the soft
key APPLY (F2) for your changes to take effect.
Fig 35
When an Autotest is run, Fig 35, the display lists the tests that are applicable
to the current mode from the list that you selected at Setup and shows the
status of each. After the Autotest is complete, or has been stopped, each
individual test can be selected and its detailed results displayed.
In Cable mode, Autotest is limited to Wiremap.
www.vemco.pl