30
M A C H I N E S P E C I F I C A T I O N S
E N
4
Machine Specifications
4.1
Delivery Scope
_
Milling machine
_
Mains cable
_
USB cable (5 m)
_
Network cable (5 m)
_
Service unit, compressed air
_
Compressed-air hoses (300
mm and 1950
mm)
_
Service set for spindle
_
Torque wrench
_
Blank holder
_
Calibration body
_
Calibration pin
_
White oil for maintenance of the A-axis
_
Grinding-point set consisting of 1.8 mm, 1.4 mm,
1.0 mm und 0.4 mm grinding points
▷
After unpacking, check the machine for com-
pleteness and possible transport damages.
Please claim any transport damages immedi-
ately with your supplier.
4.2
Intended Use
The milling machine is a PC-controlled milling and
grinding machine for the fabrication of dentures
by means of wet processing of blanks made of
_
sintered glass ceramics
_
Plastics
_
Metals
Using blanks and tools not approved by the manu-
facturer can damage the machine and make the
product unusable. For such cases, the manufac-
turer shall assume no liability whatsoever.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
4.3
CE Declaration of Conformity
This product was designed and manufactured
based on careful selection of the harmonised
standards to be observed, as well as additional
technical specifications. It thus corresponds with
the state-of-the-art and ensures maximum safety.
In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
The product's Declaration of Conformity can also
be viewed on the manufacturer's website.
EC Guidelines
Applied harmonised
standards
2006/42/EC
(Machinery Direc-
tive)
DIN EN ISO 12100 2011-03
DIN EN 13128 2009-09
2004/108/EC
(EMV directive)
DIN EN 61010-1 2011-07
DIN EN 55011 2011-04
DIN EN 61000-4-4 2010-11 /
61000-4-5 2007-06
Tab. 1
