ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 102 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
4
5. Main Voltage Selection
The Model 252 has been designed to run on voltages from 1VAC to 240VAC 50/60Hz. No
voltage selector switching or changes to the applicator are required. Refer to the printer
manual for possible required changes.
6. Motor Direction Selection
The Model 252 rewind assemblies (left hand or right hand) use the same motor, the direction
of which can be easily reversed to match the required rotation direction. If the motor is
rotating in the wrong direction, the rewind assembly will not work. The directional arrow
located on the end of the rewind spindle indicates the rotation direction required. Reversing
the motor rotation direction is as simple as plugging the motor into the provided connector on
the PCB in the electronics assembly.
Start by removing all power and air from the applicator. Next, remove the back cover from
the applicator using a 3mm hex wrench.
Before attempting to service machinery, the machine must be turned off
and the power and air locked out.
On the PCB, locate the connectors labeled RH (J14A) and LH (J14B). Remove the motor lead
wire plug from the connector it is now plugged into, (LH or RH), and plug it into the
connector labeled for the opposite direction. The motor should now be rotating in the opposite
direction. After the correct motor rotation direction has been selected, carefully reinstall the
back cover.
Most of the illustrations in this manual depict a Right Hand applicator. When
viewing the operator interface such that the print engine or apply only module is
directly below it, if the peel tip or the label feed direction is to the right, it is a
Right Hand applicator. If the peel tip or label feed direction is to the left, it is a Left
Hand applicator.