ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 30 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
5
2.1 Assembling the Stand Components
There are a multitude of mounting options available, depending on the application
requirements. For use in a fixed location, two floor plate options are available. Both
options require permanent attachment to the floor. The machine center of gravity must
be taken into consideration when deciding which of the other configurations is to be used
for the application.
Failure to follow mounting method requirements can cause unstable
machine mounting resulting in damage and/or injury.
The basic “T” Base assembly consists of a TS2000 “T” Base and a TS1000 Upright
Assembly. Normally, the TS1000 mounts directly to the TS2000. The Upright must be
attached to the “T” Base with the applicator mounting bolt over the long leg of the base.
If in and out adjustment is needed, and the upright position can vary, a TS3000 Slide
Base can be mounted between the TS2000 and the TS1000 Upright.
If the upright position must remain stationary, adding the TS4000 Traversing Post will
allow the same range of adjustment. Also, the TS4000 is used when the applicator must
be mounted from above.
An additional 12” of height is available by utilizing the TS5000 Extension Post. It can be
mounted on the TS3000 Slide Base or directly to the TS2000 “T” Base.
Refer to the following illustration for guidance.
WHEN THE TS8000 OR TS8001 FLOOR PLATE
IS NOT USED, THE APPLICATOR CENTER OF GRAVITY
MUST BE LOCATED WITHIN THE TRIANGULAR AREA
INDICATED TO ENSURE MACHINE STABILITY.