ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 34 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
9
2.4 Mounting the 252E Applicator
The 252E Printer/Applicator can be mounted with two different basic mounting options.
The first of the two is a “U” arm similar to the 252 “U” arm. The other option is an
adjustable height pedestal base. The pedestal base option is normally used for fixed
position application configurations.
2.4.1 252E U-Arm Installation
The 252E U-Arm Mounting Assembly is utilized to mount the 252E in the same manner
as the 252. The “U” arm has an alternate enclosure mounting position which can be used
to extend the applicator away from the upright. This is especially useful when used with
a wide conveyor. A stabilizer block is provided with the 252E as extra support when the
“U” arm is mounted in a vertical position. An adjustable tilt attachment is also included
to aid in fine tuning to the optimum operating position.
If the “U” arm is not attached to the 252E from the factory, it should be installed before
mounting to any other support. To install the “U” arm on the cabinet, remove the 20mm
mounting bolts along with all of the associated washers from the cabinet. Position the
“U” arm over the cabinet aligning the mounting holes. Place the washers in line with the
mounting holes and, in the correct order, secure each set with the 20mm hex head bolt.
Failure to install the washers in the correct order can affect proper sealing of the
enclosure and result in damage to the equipment.
M20 BOLT
M20 SPLIT WASHER
M20 FLAT WASHER
3/4" FLAT WASHER
SEALING WASHER
ID100172