ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 24 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
5
6.12 Dual Panel Module
The Dual Panel Module is a special application unit that combines a straight tamp and a
swing arm tamp to apply labels to two adjacent panels of a carton. The dual panel
module utilizes special firmware to provide the controls required to perform the desired
application cycles.
6.13 Corner Wrap Module
The Corner Wrap Module is a special application unit used to place labels on the corners
of containers. The module allows equal lengths of a label to be applied on two adjacent
sides of a box corner. A roller is used to apply pressure to the label as it comes in contact
with the product. Supplied with the needed connections and hardware, the module is
mounted to the baseplate in the same attachment location as the tamp units. Special
orientation and setup may be required when using a corner wrap module.
6.14 Main Air Cutoff
The main air cutoff upgrade can be installed on the filter regulator assembly supplied
with the tamp upgrade. The cutoff provides a quick method of disconnecting the
applicator from plant air, venting all residual pressure in the applicator and providing a
lockout point for maintenance. Installation instructions can be found in the drawings
section of this manual.
6.15 Water Separator
The water separator upgrade can be installed on the filter regulator assembly supplied
with the tamp upgrade. The water separator is useful when there is excessive dirt, oil or
water present in the compressed air supply. The assembly provides an additional three
stages of contamination removal to the standard filter regulator. Installation instructions
can be found in the drawings section of this manual