ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 114 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
16
12.2 Drive Belt Replacement
To replace the drive belt, place the belt in the drive groove on the rewind spindle. Holding the
belt from the top of the flange, slide the rewind spindle onto the shaft. Rotating the tensioner
arm as before, rotate the belt toward the drive pulley, ensuring that the belt is placed properly
over the bearings. Slip the top portion of the belt over the top of the drive pulley and pull the
belt or rotate the pulley until the belt is seated in the drive pulley. Release the tensioner arm
and verify that tension is applied to the belt.
12.3 Drive Pulley Replacement
To replace the drive pulley, remove the drive belt and rewind spindle. Rotate the drive pulley
until the set screw holding the pulley in place on the motor shaft is exposed. Remove the set
screw, and slide the drive pulley off of the motor shaft. Place the new drive pulley on the
motor shaft, install the set screw, and tighten, positioning the drive pulley hub as shown.
Once the new drive pulley is correctly installed, reinstall the drive belt and rewind spindle.
0.08 - 0.10