ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 43 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
18
Insert the 1/4" black, blue and grey tubes into the appropriate fitting in the manifold. A
color cap on the fitting will aid in selecting the correct port. Install the yellow tube into
the “Y” fitting on the vacuum generator, again looking for the colored cap designating
the correct location. Replace the back cover and reconnect any cables disconnected
during removal.
3.9.2 Air Assist Bracket and Tube
Next, install the air assist bracket and tube. Locate the air assist bracket, a black slotted
part that resembles a lower case “j” and install it on the rear of the baseplate. Using a
3mm hex wrench, install the M4x20 cap screws, split and flat washers, to affix the
bracket to the baseplate. Using the same 3mm hex wrench, loosen the small M4x12
clamping cap screw at the lower end of the clamp. Locate the air assist tube, a stainless
steel tube with a series of small holes along the length. Note that the holes are located
nearer to one end of the tube than the other. Also, the end of the tube with the nearest
holes is plugged. Insert the non-plugged end into the front of the bracket and slide the
tube through the bracket until the plugged end reaches the outboard side of the peel tip.
The holes in the air assist tube should roughly match the upward and outward angle of the
slot in the air assist bracket. Tighten the clamp screw with the 3mm hex wrench. Finally,
install the blue tube over the end of the air assist tube until approximately 1/4 to 1/2 inch
of the air assist tube is inside the blue tube.
BLUE TUBING
GREY TUBING
YELLOW TUBING
BLACK TUBING
(1/4")
BLACK TUBING
(5/16")
YELLOW TUBING