ID Technology 252, Инструкция оператора / Техническое руководство

Страница: 39 / 164

Model 252
Label Printer/Applicator
Operators/Technical Manual
14
3.5 Product Detect Photocell
Locate the optional product detect photocell and optional mounting bracket. Depending
on the type of photocell purchased, there may be a reflector and a second bracket kit
included. Mount the photocell to the mounting bracket and install on the production line
so the midpoint of the bracket adjustment sees either the leading or trailing edge of the
product at approximately the same time as the label dispense should begin. If the
photocell is a through beam type with a reflector, mount the reflector bracket on the
opposite side of the conveyor with the reflector directly across from the sensor.
On the rear of the applicator, insert the nine pin D style connector into either of the two
sockets available. It is not important which socket is chosen as any one will function
properly with compatible accessories. Tighten the retaining screws on the connector
body to insure it does not come loose during operation.
3.6 Interface and Power Cables
Plug the Printer Interface cable into the 15 pin “D” style connection on the rear panel of
the electronic assembly. Plug the other end into the printer. Tighten the retaining screws
on the connector bodies to insure they do not come loose during operation. Plug the main
power cord into the power entry module on the rear panel of the electronic assembly. Do
not plug the permanently attached power cord into the power entry module.
3.7 Three Stage Indicator Beacon
Locate the optional three-stage indicator beacon assembly and mount it in the desired
location where it will be easily visible to the line operators. On the rear of the applicator,
insert the nine pin D style connector into either of the two sockets available. It is not
important which socket is chosen as any one will function properly with compatible
accessories. Tighten the retaining screws on the connector body to insure it does not
come loose during operation.
The 252N applicator provides a suggested position for the three stage
beacon. Alternate positions are available with the use of the included
mounting bracket.