Innovative Circuit Technology Ltd.
2
WARNING
Risk of serious personal injury or damage to equipment and property! Always
observe the following:
•
Shut off or disconnect all dc power sources before connecting or
disconnecting wiring
•
Use wire and connectors rated for the maximum load current and size of
circuit breaker, and keep cable lengths as short as practical
•
Carefully observe wiring polarity when making input and output connections
•
Securely tighten all connections
•
Do not attempt to service any internal parts. Refer all product service to ICT or
an authorized ICT Service Provider
CAUTION
Risk of personal injury or damage to equipment! Always observe the following:
•
Install unit in a restricted access location (such as an equipment rack) to limit
unintentional contact with terminals and wiring
•
Ensure the total power consumption of the loads does not exceed the 100
amperes rated capacity of each power bus
•
Ensure load current through each output channel does not exceed 20
amperes
•
Do not block air inlet or outlet openings in the panel sides
•
Remove all fuses before connecting or disconnecting wiring
NOTE:
Due to the fuse
detection circuitry internal to the distribution panel, it may be
possible to measure a voltage on the output terminal(s) even if that output’s
fuse is open (with no load connected). This is normal operation. The detection
circuitry is a high-impedance circuit, and while a voltage may be present on the
output terminal, it is purely a signal voltage and does not support loading. Any
load device connected to the output will immediately pull this voltage to zero
volts.
Rev 1
2022
Copyright © 2022 Innovative Circuit Technology Ltd. All rights reserved. No part of this
publication may be reproduced, stored in a retrieval system or transmitted in any form or by
any means, electronic, mechanical, photocopying, recording or otherwise, without the prior
written consent of Innovative Circuit Technology Ltd.