ICP GDT RS Series, Руководство пользователя

Страница: 78 / 186

78
Note: Drives run with corelSCSI and the UNI_ASP.SYS driver are neither compatible with
drives run with ICPCON and the ICP cache nor with those run with the above mentioned
ASPIDISK.SYS driver.
D.7 Installing Windows 95
This guide will take you through the process to install the files necessary to allow the con-
troller to operate under Windows 95.
We differentiate three cases: The ICP Controller is the primary controller, the ICP Controller
is the secondary controller, and the ICP Controller is already installed under Windows 95
and its driver should be updated.
D.7.1 The ICP Controller is the primary controller
You must create an MS-DOS partition on and format the drive to which Windows 95 is to
be installed. You also need a CDROM that is fully accessible under MS-DOS.
1. Transfer the WIN95 files from the ICP System CDROM to a 3.5” floppy disk. The files are
located in the directory, (your CDROM drive letter):\DRIVERS\WIN95. You will need this
disk later in the Windows 95 Setup.
2. Power-on the system. Press Ctrl+G to enter the ICPCON program.
3. Select the controller - ENTER . Press F2 to enter Advanced Setup .
4. Highlight Configure Controller - ENTER . Highlight Controller Settings - ENTER .
5. Highlight Delayed Write - ENTER . Highlight OFF - ENTER . Delayed write is now dis-
abled. This is done to ensure all files are written immediately to the Host Drive during
the Windows installation.
6. Press Esc . A message appears: "Do you want to save changes?” Press <Y> .
7. Install Windows 95 per instructions provided with the program.
8. After installation: double click My Computer icon. Double click the Control Panel icon.
9. Double click the System icon. Click the Device Manager tab.
10. Double click Other Devices . Double click PCI SCSI Bus Controller .
11. Click Driver . Click Change Driver . Double click SCSI Controllers .
12. Click Have Disk . Insert the ICP Windows 95 driver disk you created in step 1.
13. Click OK . Click OK again. Click OK again.
14. Click Cancel . Never click Test. Windows 95 is unable to determine if the ICP BIOS
can be removed. Using the Test option may cause the system to freeze.
15. Remove the ICP Windows 95 driver disk. Restart the system.
Upon completion of the Windows 95 installation you will need to load the ICPCON
program to Windows 95. The following steps will take you through this process.