Icom SB-110, Инструкция по эксплуатации, Страница: 87 / 102

75
MAINTENANCE
6
6
6-6 Upgrading SB-110
■
Firmware (continued from the previous page)
◆ Before using Utility ◆
To upgrading the firmware with Utility, enter the [Use utility] mode. Otherwise, you cannot
use Utility to update the firmware. You need to access SB-110 and assign the IP address
to your PC in advance.
<How to enter [Use utility] mode>
This section describes the procedure to enter the [Use utility] mode using the [MODE] but-
ton. You may also enter the [Use utility] mode through the [Administration] screen
(
☞
see 5-5).
1. Remove the power supply from SB-110.
2. Remove all the network devices from SB-110.
3. Connect an AC adapter to SB-110 holding down the [MODE] button and turn on the
power supply.
4. Release the [MODE] button before the [PWR] indicator and [MODE] indicator, which
were blinking (in green) alternately, start blinking (in green) simultaneously.
¡ Enter the [Use utility] mode and start an operation.
◆ Notes on Updating ◆
To prevent an error in firmware transfer, connect one PC, in which Utility is installed, to
one SB-110 through cable or by wireless. It is advisable to connect the PC and SB-110
through a hub on Ethernet LAN (
☞
see 4-1).
¡ If you connect the PC and SB-110 by wireless, follow the instructions below.
Enable the Access Point mode (
☞
see 4-3).
Disable the wireless LAN security (WEP function) of the PC.
Remove the SB-110's Ethernet cable from the PC.
Keep the wireless communication distance to SB-110 1 m or less.
[Use utility] mode
When the [Use utility] mode is enabled by operating the [MODE] button, the wireless LAN se-
curity setting (WEP function) of SB-110 is disabled temporarily until Utility operation has been
completed actually. If Utility is used in a wireless terminal, disable the WEP function of a PC.
You are responsible for the result of operation described herein. So, please follow the
instructions below when you start an operation.
◎
The CD-ROM (excluding Acrobat Reader) which comes with SB-110 is for SB-110 only. Do not
use it for any other devices.
◎ Icom Inc. is not responsible for any interference arisen by incorporating a configuration file for SB-
110 or a firmware update data file, which is available in our home page, into any device other than
SB-110. Moreover, Icom Inc. is not responsible for any interference arisen by modifying or disas-
sembling SB-110. Furthermore, Icom Inc. is not responsible for any damages, lost profits or third
party's claim resulting from any missed communication or telephone call due to SB-110's fault,
error, malfunction, breakage, data loss or any other external factor such as power failure.
PDF取説-E̲1 02.1.23 10:28 ページ75