Icom SB-110, Инструкция по эксплуатации, Страница: 51 / 102

39
SETTING SB-110
4
4
4-6 Changing Automatic Assignment Start IP Address
If the network section of the IP address of SB-110 is changed to enable the DHCP server
function of SB-110, the network section of the automatic assignment start IP address also
must be changed. This section describes how to change the automatic assignment start IP
address.
<How to change>
1. Access the SB-110 setting screen according to the procedure described in 4-1 and 4-2.
¡ The [Wireless LAN Settings] screen is shown.
2. Click [IP address] in the left frame.
¡ The [IP address] screen is shown.
3. Change the automatic assignment start IP address and click [Set & Reboot].
¡ "Now rebooting" is displayed on the screen and the specified details are enabled.
【 DHCP Server Function 】
If the DHCP server function of SB-110 is enabled (the default setting), the IP address can be obtained from
SB-110 automatically when a PC has been connected to SB-110.
When you connect SB-110 to an existing LAN, the IP address assigned by SB-110 must be different from
the fixed IP address assigned to any existing network device (e.g., PC etc). Moreover, the network section
must be the same as that of the IP address of SB-110.
【
The Number of IP Addresses Assigned Automatically
】
The number of IP address assigned by SB-110 automatically is 5 to 128. For the default assignment start
IP address and subnet mask set value, the maximum number of IP addresses which can be assigned log-
ically is 254. However, if you assign 128 addresses or more, those addresses should be assigned to the
clients manually.
Click
1.
Not need to be changed
unless routing mode is
used.
Change
2.
4. If the DHCP server function of SB-110 is enabled, obtain the IP address again using
"winipcfg.exe" (
☞
see 3-4) or restart the PC.
Click 3.
PDF取説-E̲1 02.1.23 10:28 ページ39