iCanView110/110W User’s Guide
Rev.1.4 (Jan. 2005)
13 of 56
5.
Connect to iCanView110 in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when iCanView110 is delivered to you. You
are asked to configure the system for your environment in administration mode. Detailed
information of using administration mode can be found in
[
5.
Configuring the A/V Server
in Administrative Mode]
. Among the parameters, the parameters in the following table
should be set-up in proper values. Detailed information for the parameters in Administrator
Mode is found in
[
5.
Configuring the A/V Server in Administrative Mode]
[Note]: Set-up values are preserved even the power is turned off.
Page
Parameter
Setup value
Factory default value
Video Size
Define the resolution of the video
transmission from iCanView110.
Max Upload Rate
Set this value smaller than the upload
speed of your network.
Frame Rate
It indicates the number of frames to
be transmitted per second.
Basic Setup
Video Rate
It indicates the bandwidth allowed for
video transmitted from iCanView110.
Make sure that you press Check
button to find out the number of
maximum possible simultaneous
users then set the number of
users smaller than or equal to the
number.
User Admin
& Time
Setup
Administrator
name &
password
For safety, you are recommended to
change these values from factory
default. For new connection, you need
to input changed values for
corresponding fields. Do not expose
these values to others and memorize
these values.
Default value
Username : root
Password : dw2001
User Admin
& Time
Setup
Current Time
Input correct time in this field.
Default value :
2001/1/1
6.
Connect the inputs and output signals to iCanView110.
iCanView110 does not function properly if there is no video and audio input.
Refer to the following table. You have to connect at least one Video In.
Connectors
Function
Signal description
Number
Video In
Input video
Analog video outputs from analog
1
