iCanView110/110W User’s Guide
Rev.1.4 (Jan. 2005)
12 of 56
2.4. PC Requirements
AV streaming data from iCanView110 can be observed through i-NVR program which is a viewing &
recording program running on a PC. Minimum requirement of the PC is described below:
Minimum
Recommended
CPU
Pentium III 700
Pentium IV 1.2G above
Main Memory
128 MB
256MB above
Operating system
*
Windows 2000 or later
Windows 2000 or later
Web browser
Internet Explorer 5.0
Internet Explorer 5.0 above
Resolution
1,024 X 768
Higher than 1,024 X 768
Network 10
Base-T
Ethernet 10/100
Base-T
Ethernet
* Operating Systems supported : Windows 2000 Professional
Windows XP Professional / Windows XP Home Edition
2.5 Quick Installation Guide
Brief information for rapid installation is provided in this section. For more detailed information you
are recommended to refer to pertinent documentations provided with the product or refer to
iCanTek’s home page
(http://www.icantek.com)
1.
Connect iCanView110 to your PC or network by using one of the following method
i. Connect your PC and iCanView110 using the Cross Type LAN cable provided with
iCanView110 or
ii. Connect iCanView110 and PC to same LAN using Direct Type cable.
2.
Apply power to iCanView110
3.
Install “IP installer” and “i-NVR” on your PC.
Detailed information for installing these programs can be found in
[IP-Installer User’s
Guide]
and
[i-NVR User’s Guide]
in this CD
,
respectively.
4.
Assign IP address to iCanView110 using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide]
.
If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
