IBM SAN768B-2, Руководство пользователя

Страница: 162 / 228

Items required
v
ESD (electrostatic discharge) grounding strap
v
Workstation computer
v
Port blade
v
Phillips screwdriver
v
SFP+ transceivers (as needed) or QSFP transceivers (included with FC3664)
v Optical cables (as needed)
v
FC3664 (64-port blade) requires FOS 7.3 or later
Procedures
Follow the links in the steps below to complete this installation:
1.
Verify that the port blade is the correct part: 99Y0347 for the 32-port blade,
99Y0350 for the 48-port blade, and 00MA716 for the 64-port blade.
2. Verify which slot to install the blade. Slots are numbered from one through
twelve, from left to right, when facing the port side of the SAN768B-2s. Port
blades can be installed in any of the slots 1-4 and 9-12.
3. IBM recommends having the latest firmware version on the CP blade. The
firmware version should match on both the active and the backup CP blades. If
the firmware is not at the latest level, obtain new code from the code download
website, and install it prior to installing the port blade. See “Fabric OS
firmware updates” on page 50 for instructions.
Note: Firmware downloads require that Ethernet connections be made to both
CP blades. Procedures for downloading and installing firmware are described
in the
Fabric OS Administrator's Guide .
4. Remove the filler panel or port blade. Refer to “Removing a port or application
blade” on page 84 or “Removing a filler panel” on page 87.
Attention: A filler panel should be removed only when being replaced with a
port blade or new filler panel. Any slot that is not occupied by a port blade
should be occupied by a filler panel to ensure correct cooling of the chassis and
protection from dust.
5. Follow the instructions for “Installing a port or application blade” on page 86.
6.
Follow the instructions for “Removing and installing transceivers” on page 108.
Because of port density, it may be easier to remove and install the SFP+
transceivers while the 32-port or 48-port blade is out of the chassis. However,
you must handle the blade carefully while it is out of the chassis to avoid
damaging the blade and the transceivers.
Note: FC3664 (64-port blade) uses 16 QSFPs instead of SFP+ transceivers.
7. Install, group, and route the cables. See “Managing cables” on page 46 for
additional cabling instructions.
Attention: Do not route cables in front of the exhaust vent, which is located at
the top on the port side of the chassis.
8. Verify the installation. For information about how to check the status of
hardware components using the CLI, see the
Fabric OS Administrator's Guide ,
which is located on the product documentation CD.
134
SAN768B-2 Installation, Service, and User Guide
|
|
|
|
|