IBM SAN768B-2, Руководство пользователя, Страница: 119 / 228

Removing a control processor blade (CP8)
The SAN768B-2 continues to operate while a CP blade is being installed if the
redundant CP blade is active and a failover does not occur. You can prevent
failover by entering the
haDisable
command.
Attention: Follow ESD precautions (see “ESD precautions” on page xix) when
handling any blades.
Complete the following steps to remove a CP8 control blade (CP).
1. Remove the chassis door. (See “Removing and installing the chassis door” on
page 81.)
2.
Log in to the active CP as the
admin
. You can use a serial cable or Telnet, Web
Tools, or Fabric Manager. Determine which CP is active using the
haShow
command or view the active LED on the front of the CP.
3. If the faulty CP is the active CP, issue the
haFailover
command. Wait until the
failover has completed. Use the
haShow
command to verify the CPs are
synchronized and the failover is complete. Depending on the nature of the CP
failure, it is possible that the
haFailover
command will not work. Proceed to
the next step anyway.
4. Enter the
haDisable
command. This is required before physically removing and
replacing a CP blade.
5. Power off the blade you are replacing by sliding the slider switch in the top
ejector down, to the off position. Do not eject the blade until the power LED is
off and you have completed the next two steps.
6. Disconnect all cables from the faulty (standby) CP blade you are replacing.
7.
Unscrew the thumb screws from both ejectors using the Phillips screwdriver.
8. Lever open both ejector handles simultaneously to approximately 45 degrees
and pull the CP blade out of the chassis (see Figure 33 on page 92).
Chapter 5. Removing and installing components
91