IBM SAN768B-2, Руководство пользователя

Страница: 136 / 228

6. Verify that the WWN cards are correctly connected by checking the LEDs on
the WWN cards to see if they reflect the status of the components.
Note: The LEDs may take up to two minutes after WWN card installation to
begin functioning.
7. Install the WWN bezel. Orient the bezel on the chassis (see Figure 38 on page
107). Insert and tighten the two screws.
8. Verify the new card settings by running the following commands and
comparing the output with the original
supportsave data.
v licenseIdShow
v ipAddrShow
v switchName
v chassisName
v wwnCardShow ipdata
v chassisShow
(look at the WWN and chassis information at the bottom)
v ficonShow switchrnid
9. Run the
switchcfgpersistentenable
command to persistently enable each
logical switch that was disabled before removing the WWN cards.
switch:FID128:root> switchcfgpersistentenable
Switch’s persistent state set to ’enabled’
10. Pack the faulty WWN cards in the packaging provided with the new cards for
return to IBM for failure analysis, following local procedures.
Removing and installing transceivers
Use the instructions in this section to remove and replace transceivers.
Attention: Use only transceivers that are supported for this product. Only
transceivers purchased from IBM are supported. The use of transceivers that are
not supported may cause data loss or cause the product to malfunction. For a
listing of transceivers compatible with this product:
v
Go to the IBM Support Portal http://www.ibm.com/supportportal.
v In the Search field, enter b-type supported transceiver .
v
Alternatively, use this direct link: http://www-01.ibm.com/support/
docview.wss?uid=ssg1S1004421
Table 15. Transceiver types and speeds by blade model
Blade Transceiver Auto negotiate/Fixed
Speeds supported
(xGbps)
FC8-32E and FC8-48E SFP+ Auto negotiate 2, 4, and 8
FC8-64 mSFP Auto negotiate 2, 4, and 8
FC16-32 and FC16-48 SFP+ Auto negotiate 2, 4, 8, and 16
FC16-32, FC16-48,
and 10-Gbps SFP+ Fixed 10
FCOE10-24 10-Gbps SFP+ Fixed 10
FC16-64 QSFP Auto negotiate 4, 8, and 16
However, all the four
ports within a
quad-SFP should be
of the same speed.
108
SAN768B-2 Installation, Service, and User Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|||
|
|
||||
||||
||||
|
| |||
||||
||||
|
|
|
|