IBM SAN768B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 137 / 186

svc00168
32-55 kg (70.5-121.2 lbs)
CAUTION:
The weight of this part or unit is at least 47 kg (104 lb) with all
components removed. It takes specially-trained persons and/or a
lifting device to safely lift this part or unit. (C011)
Attention: Do not place a SAN768B-2 chassis directly on the floor. It cannot be
easily moved from the floor back onto a lift or pallet.
1. Uninstall the chassis from the cabinet (see “Removing a SAN768B-2 from the
cabinet” on page 29 for detailed steps) and place it onto an extra lift or on the
shipping pallet originally provided with the chassis. Remove the mounting
brackets, and set the hardware aside for use with the new chassis.
2. Unpack the new chassis (see “Unpacking the SAN768B-2” on page 17
3. Attach the brackets to the new chassis (see “Attaching the shelf brackets” on
page 18)
4.
Install the new chassis in the cabinet, using a lift tool to raise the chassis to the
correct level. See “Using the lift tool, the 24–inch load plate, and the bridge
tool” on page 20 for detailed steps.
Installing components into the new chassis
Install the components into the new SAN768B-2 chassis in the order listed below.
Refer to Chapter 5, “Removing and installing components,” on page 67 for more
specific installation information.
Attention: Do not force the installation of any of the components. If the
component does not slide in easily, ensure that it is correctly aligned and
positioned before continuing.
Attention: Do not turn on the power until it is time to verify hardware operation
Attention: Follow ESD precautions (“ESD precautions” on page xix)
1. Install the WWN cards and bezel in the new chassis as described in “Installing
the WWN bezel and WWN card” on page 91.
2. Install the blower assemblies in the new chassis as described in “Removing
and installing a blower assembly” on page 88.
3. Install the power supplies or filler panels in the new chassis as described in
“Removing and installing a power supply” on page 86.
4.
Install the control processor (CP8) blades in the new chassis as described in
“Removing and installing a CP8 control processor blade” on page 73.
5. Replace the core switch blades (CR16-8) as described in “Removing and
installing a core switch blade (CR16-8)” on page 83
6. If QSFP cables are not used, insert the rubber plugs in the sockets in the QSFP
transceivers.
7. Install the port, application blades, or filler panels in the new chassis as
described in “Installing a blade” on page 71 or “Installing a filler panel” on
page 73.
8. Replace the cable management comb “Removing and installing a cable
management comb” on page 68
9.
Connect the power cords to the power supplies and the power outlets.
10. Install the chassis door as described in “Removing and installing the chassis
door” on page 67.
Chapter 5. Removing and installing components
107