IBM SAN768B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 123 / 186

Note: This tool is part of the SAN768B-2 ship group and should be kept with the
chassis.
Attention:
mSFP optical transceivers should not be inserted into ports intended
for SFP+ transceivers. They will be faulted on power-up.
Removing an SFP+ optical transceiver
Complete the following steps to remove an SFP+ transceiver.
Note: The 16 Gbps SFP+ transceivers have an attached pull tab like the mSFPs.
Instead of using the extraction tool, simply grasp the pull tab and pull it
straight out to remove the 16 Gbps SFP+ and the connected cable from the
port (Figure 34). Detach the cable from the 16 Gbps SFP+ once you have
disconnected the unit from the port. See the mSFP transceiver in Figure 36
on page 95 for the basic appearance of the 16 Gbps transceiver.
Complete the following steps to remove an SFP+ with an attached wire bail.
1.
Remove any cables that are inserted into the transceiver. Use the extraction tool
to open the cable latching mechanism.
2. Using the hooked end of the tool, pull the bail (wire handle)
1
away from its
pivot point and out, sliding the transceiver out of the port (Figure 35 on page
94).
bm480020
Figure 33. Optical transceiver (SFP+) extraction tool
!
b48f012
Figure 34. Installing and removing a 16 Gbps SFP+ with pull tab (shown without cable
attached)
Chapter 5. Removing and installing components
93