IBM SAN768B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 67 / 186

Setting the Domain ID
Each switch in the fabric must have a unique Domain ID. The Domain ID can be
set using the
configure command or can be automatically set. The default Domain
ID for the SAN768B-2 is " 1 ".
To set the Domain ID, follow these steps:
1. Enter the switchDisable command to disable the SAN768B-2.
2. Enter the configure command.
3. Enter y at the " Fabric parameters " prompt:
Fabric parameters (yes, y, no, n): [no] y
4. Enter a unique Domain ID:
Domain: (1..239) [1] 3
5. Complete the remaining prompts or press Ctrl+D to accept the settings and to
exit.
6. Enter the switchEnable command to re-enable the SAN768B-2.
Setting the date and time
The date and time settings are used for logging events. Switch operation does not
depend on the date and time; a switch with an incorrect date and time value still
functions properly. However, because the date and time are used for logging, error
detection, and troubleshooting, they should be set correctly.
Setting the date
To set the date, follow these steps.
1. If necessary, log on to the SAN768B-2 by Telnet, using the admin account. The
default password is password .
2. Enter the date command, using the following syntax: date "mmddHHMMyy "
Where:
v
mm is the month; valid values are 01 through 12.
v
dd is the date; valid values are 01 through 31.
v HH is the hour; valid values are 00 through 23
v
MM is minutes; valid values are 00 through 59.
v yy is the year; valid values are 00 through 99 (values greater than 69 are
interpreted as 1970 through 1999, and values less than 70 are interpreted as
2000-2069).
switch:admin> date
Fri Sep 24 17:01:48 UTC 2010
switch:admin>
date "0927123010"
Mon Sep 27 12:30:00 UTC 2010
switch:admin>
Setting the time zone
You must perform the procedure on all chassis for which the time zone must be
set. However, you only need to set the time zone once on each switch, because the
value is written to nonvolatile memory. Use one of the two following procedures
to set the time zone.
Chapter 3. Starting and configuring the SAN768B-2
37