IBM SAN768B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 164 / 186

Table 25. Environmental status and maintenance commands
Command Information Displayed
sensorShow
v Temperature readings for the port blades
v Temperature readings for the CP blades
v Status and RPM of all operational fans
v Status of all operational power supplies
tempShow
v
Temperature readings for the port blades
v Temperature readings for the CP blades
psShow Status of all operational power supplies
fanShow Status and RPM of all operational fans
chassisShow Serial number, time awake, and additional information about
each component
slotShow Slot occupancy
errShow
errDump System error log. Refer to the Fabric OS Message Reference for
more information on the messages in this log.
Interpreting POST and boot results
The SAN768B-2 performs power on self test (POST) by default each time the
system is powered on, rebooted, or reset. The system can be rebooted using the
reboot (to reboot each CP individually), or fastBoot commands. The fastBoot
command reboots the system without running POST. If the active CP blade is
rebooted, it fails over to the standby CP blade.
POST
The system automatically performs POST each time it is powered on or reset.
To verify that POST has completed without error:
v Verify that all LEDs return to a normal state after POST completes (see
Chapter 4, “Monitoring system components,” on page 45).
If one or more LEDs do not return to a normal state, and this is not due to the
SAN768B-2 being set to beacon, refer to the relevant LED table to identify and
correct the problem. For port blades, CP blades, and core switch blades, the
slotShow command can be used to check the status of the slots. For information
about turning beaconing on/off, refer to the Fabric OS Administrator's Guide .
v Verify that the switch prompt displays when POST completes.
If it does not display, POST was not successfully completed. Contact IBM for
support.
v
Review the system error log using the errShow or errDump commands.
v Any errors detected during POST are written to the system log, which is
accessible through the
errShow command. For information about error
messages, refer to the Fabric OS Message Reference .
POST includes the following steps:
1. Preliminary POST diagnostics are run.
2. Operating system is initialized.
3. Hardware is initialized.
134
SAN768B-2 Installation, Service, and User Guide