IBM SAN768B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 51 / 186

Attention: Before you install it, verify that the additional weight of the chassis
does not exceed the cabinet's weight limits or unbalance the cabinet. When you
calculate the additional weight, include the cards or power supplies that partially
extend out of the chassis.
P/N 18P5850-B
SJ000752
CAUTION:
A pinch point exists between the load plate and the bridge tool.
Perform the following steps to install the SAN768B-2:
1. Assemble the lift tool if it is not assembled. The assembly and disassembly
instructions are included with the lift tool.
2. Attach the 24–inch load plate to the lift tool.
3.
Although not required, you can remove the power supplies and blower
assemblies from the SAN768B-2 to reduce the weight. This can reduce the
weight by up to 27 kg (60 lb).
4. Move the lift tool next to the pallet that contains the SAN768B-2.
a.
Adjust the load platform to the same height.
b. Slide the SAN768B-2 from the pallet onto the load platform.
c. Center the switch on the load platform.
5. Attach the retention straps around the drawer.
6. If the load platform is not at its lowest position, lower the load platform to its
lowest position.
7. Move the lift tool to a position near the rear of the cabinet. See Figure 7 on
page 22.
Chapter 2. Installing and removing a SAN768B-2
21