IBM SAN Volume Controller 2145-CG8, Руководство по техническому обслуживанию аппаратной части

Страница: 57 / 372

Table 23. Cable-management arm and associated parts descriptions and quantities
Reference Description Quantity
1
Slide rail (left) 1
2
Slide rail (right) 1
3
M6 screws 4
4
Large cable tie 1
5
Cable ties 5
6
Cable-management support arm 1
7
Cable-management arm assembly 1
To remove the cable-management arm, perform the following steps:
1. Remove all power from the node, as described in MAP 5350 in the IBM System Storage SAN Volume
Controller Troubleshooting Guide .
2. Disconnect all cables from the back of the node.
3. Slide the node away from the back of the rack.
a. Remove any optional M6 screws, as shown by
1
in Figure 10 on page 28, from the front of the
node.
b. To release the node from the rack, press the orange release latches
2
and slide the node forward
until it latches in the service position.
Cable management arm kit
Friction rail kit
7
5
6
3
4
1
2
Figure 9. The cable-management arm, support rails, and associated parts of the 2145-CG8 and 2145-CF8
Chapter 2. Removing and replacing parts
27