IBM SAN Volume Controller 2145-CG8, Руководство по техническому обслуживанию аппаратной части

Страница: 230 / 372

1
Slot 2 connector
2
High-speed SAS adapter
4. Grasp the high-speed SAS adapter assembly to steady it while you align and attach the adapter
assembly to the back rail with the two M3 screws that were removed during the removal of the
adapter.
The high-speed SAS adapter assembly and the Fibre Channel adapter assembly each attach to the
back rail with two screws (
1
), as shown in the view of the rail with the high-speed SAS adapter
assembly attached in Figure 197.
5. Make sure that all cables, adapters, and other components are installed and seated correctly and that
you have not left loose tools or parts inside the node. Make sure that all internal cables are correctly
routed. If you disconnected the Fibre Channel and Ethernet cables, make sure that each cable is
reconnected to the same port from which it was removed.
6. Replace the top cover. See “Replacing the top cover” on page 81.
After following the procedure to replace the top cover, the node is installed in the rack and is turned
on.
Removing the high-speed SAS adapter, the adapter cable, and the
solid-state drive (SSD)
You can remove the high-speed adapter assembly, the adapter cable, and the serial attached SCSI (SAS)
solid-state drives (SSDs) in the SAN Volume Controller 2145-CF8.
svc00253b
2
1
Figure 196. Replacing the high-speed SAS riser-card assembly for the SAN Volume Controller 2145-CG8 or 2145-CF8
1
svc_00219cf8b
Figure 197. High-speed SAS adapter assembly mounted in the back rail of the SAN Volume Controller 2145-CG8 or
2145-CF8
200
IBM SAN Volume Controller Hardware Maintenance Guide
|
|
|
|
|
|
|
|
|
|
|