IBM SAN Volume Controller 2145-CG8, Руководство по техническому обслуживанию аппаратной части

Страница: 247 / 372

1
Operator-information panel
2
Release tab
8. From the front of the node, carefully pull the assembly (
1
) out of the node while you move the
assembly slightly from side to side.
9. If you are instructed to return the operator-information panel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
Removing the SAN Volume Controller 2145-8A4 operator-information panel
You might have to remove the operator-information panel on a SAN Volume Controller 2145-8A4 due to
required maintenance.
Make careful note of the layout of the cables as you go through this procedure as they will need
replacing in the same position when you replace the operator-information panel.
Perform the following steps to remove the operator-information panel:
1. Turn off the node while ensuring that its data is mirrored and synchronized. See MAP 5350 in the
IBM System Storage SAN Volume Controller Troubleshooting Guide for more information.
2.
Remove the cable-retention bracket and disconnect the power cable from the node. See “Removing the
cable-retention bracket” on page 34.
3. Remove the node from the rack and place it on a flat, static-protective surface. See “Removing the
SAN Volume Controller from a rack” on page 46.
4.
Remove the top cover. See “Removing the top cover” on page 77.
5. Remove the screws (
3
in Figure 212 on page 218) that secure the operator-information panel to the
CD/DVD bay housing.
1
2
Figure 211. Using the release tab to remove the SAN Volume Controller 2145-CG8 or 2145-CF8 operator-information
panel
Chapter 2. Removing and replacing parts
217
|
|
|
|
|
|