IBM RS/6000 7043 260, Руководство по обслуживанию

Страница: 292 / 322

With the remote terminal connected to serial port 1 and defined as the primary
console device, there are two tests you can perform:
1. Does the modem drop the connection after the "System initialization complete"
message appears at the remote terminal?
If yes, this is the correct response. The modem is set up correctly.
If no, try another &Dn setting for your server's modem. See your modem manual
for this information. The &Dn command appears in three places each in three of
the sample modem configuration files
3 .
2. Does the server's modem disconnect when the power drops? You can make
this observation at the remote terminal by commanding your server to shutdown
and power off. (The AIX command
shutdown -F
does this.) Watch for the
message
NO CARRIER
on your remote terminal.
If yes, this is the correct response. The modem is set up correctly.
If no, try another &Dn setting for your server's modem. See your model manual
for this information. The &Dn command appears in three places each in three of
the sample modem configuration files
3 .
Recovery Strategy:
The recovery strategy consists of making two calls to
establish a remote session. This is the easiest solution to implement, and allows
more freedom for configuring your server's serial ports.
To set up a remote terminal session, dial into the Service Processor and start the
system. After the operating system is loaded and initialized, the connection will be
dropped. At this point, you call the server back and the operating system answers
and offer you the login prompt.
3 Only the following sample modem configuration files contain the &Dn command (in three places each):
Ÿ
modem_f.cfg
Ÿ
modem_f0.cfg
Ÿ
modem_f1.cfg
If you are using modem_z.cfg or modem_z0.cfg, you cannot control DTR response. If your remote
terminal does not disconnect after logging off, you must command the remote terminal emulator to hang
up. This then breaks the connection.
A-48
Service Guide