IBM RS/6000 7043 260, Руководство по обслуживанию

Страница: 132 / 322

Table 3-5 (Page 4 of 11). Firmware Checkpoints.
Checkpoint Description Action/
Possible Failing FRU
E154 Create PCI bridge node Go to Map 1540: Minimum
Configuration, “Step 1540-22” on
page 2-54.
If a network adapter or I\O board is
replaced, see 3-1.
E155 Probe PCI bridge secondary bus Go to Map 1540: Minimum
Configuration, “Step 1540-22” on
page 2-54.
If a network adapter or I\O board is
replaced, see 3-1.
E156 Create PCI ethernet node See the note on 3-34.
E15A Create 64 bit host (primary) PCI
controller node See the note on 3-34.
E15B Transferring control to Operating
System (service mode boot) See “Boot Problems/Concerns” on
page 3-48.
E15C Probe primary 64 bit PCI bus See the note on 3-34.
E15D Create host PCI controller node See the note on 3-34.
E15E Create MPIC node See the note on 3-34.
E15F Adapter VPD probe See the note on 3-34.
E160 CPU node VPD creation See the note on 3-34.
E161 Root node VPD creation See the note on 3-34.
E162 SP node VPD creation See the note on 3-34.
E164 Create PCI graphics node (P9) See the note on 3-34.
E168 Create PCI graphics node (S3) See the note on 3-34.
E16C GTX100P Subsystem Open request. See the note on 3-34.
E16D GTX100P Planar not detected or failed
diagnostics. See the note on 3-34.
E16E GTX100P Subsystem Open successful. See the note on 3-34.
E16F GTX100P Close Subsystem. See the note on 3-34.
E170 Start of PCI Bus Probe See the note on 3-34.
E171 Executing PCI-Delay function See the note on 3-34.
E174 Establish host connection Refer to “Boot Problems/Concerns” on
page 3-48 for general considerations.
3-40
Service Guide