IBM RS/6000 7043 260, Руководство по обслуживанию

Страница: 117 / 322

Table 3-1 (Page 24 of 28). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
4B2xxx00 Checkstop 1. Press enter on an attached ASCII
terminal keyboard to go into the
Service Processor menus.
2. Select System Information Menu.
3. Select "Read Progress Indicators
from Last System Boot" and use
the posted code indicated by the
arrow. Refer to “Service Processor
Menus” on page A-3 if you need
help. If the code is "E105" or
"0xxx", where xxx is any 3 digits ,
continue to step 4 instead of the
listed action. Otherwise, find the
code in the “SP Checkpoints” on
page 3-34 or “Firmware
Checkpoints” on page 3-37 and
perform the action shown there.
4. Attempt to reboot the system in
Service Mode, this preserves the
AIX error log. If the reboot fails,
attempt to reboot from the
CD-ROM. If the reboot is
successful, run Diagnostics in
Problem Determination mode to
determine the cause of the failure.
Otherwise continue.
5. Remove processor card in slot 2 (if
installed) and see if the problem is
resolved. If problem is resolved
replace processor card. If not,
continue.
6. Exchange processor card in slot 1
with processor card removed from
slot 2 in step 1 (replace processor
card if only one processor card is
exists) and see if the problem is
resolved. If problem is resolved
replace processor card. If not,
continue.
7. Go to MAP 1540: Minimum
Configuration, “Step 1540-2” on
page 2-33.
Chapter 3. Error Code to FRU Index
3-25