IBM Netfinity ServeRAID-4H Ultra160, Справочник пользователя

Страница: 52 / 192

Notes:
a. If you have more than one ServeRAID or SCSI adapter in your system,
make sure that the BASEDEV statement for the adapter or controller
controlling the startup (boot) device appears first in the CONFIG.SYS file
before the BASEDEV statements for other ServeRAID or SCSI adapters.
b. After you install any service packs, check the path for the IPSRAID.ADD
device driver and verify that the correct device driver is installed.
12. Restart the server.
Installing device drivers for OpenServer
Before you begin the installation, review the following information:
v
You must install logical drives as Bus Number 0 when using the MKDEV
program, regardless of the channel that the physical drives are on.
v
You must install a nondisk device, such as a CD-ROM or tape drive, as Bus
Number 1, 2, 3, or 4 relative to the channel to which it is attached. Internal
Channel 1 is Bus Number 1, internal Channel 2 is Bus Number 2, external
Channel 1 is Bus Number 1, external Channel 2 is Bus Number 2, external
Channel 3 is Bus Number 3, and external Channel 4 is Bus Number 4.
To configure the default nondisk devices during the initial installation:
1. Redefine the default tape drive in the initial boot string. For example, to install
the boot-time loadable driver IPSRAID BTLD and redefine the tape drive, go to
the
BOOT
prompt and type:
link Stp=ips(0, 1, 2, 0)
The numbers in parentheses represent the host adapter number, the bus
number, the SCSI ID, and the LUN respectively.
2. When prompted for the location of the installation CD, change the bus number
and SCSI ID, as required.
Adding IPSRAID BTLD at startup time: To install the ServeRAID device driver
for OpenServer 5.x.5:
1. At the
BOOT
prompt, type:
link
2. Press Enter; then, when prompted for the name of the package, type:
ipsraid
3. Press Enter.
4. After the kernel loads but before it runs, the
link
program prompts you to insert
the IBM ServeRAID Device Drivers for SCO Operating Systems - UnixWare
HBA and OpenServer BTLD diskette.
While the installation program copies the files, one or both of the following
messages might appear:
v Extracting BTLD distribution for ipsraid... /etc/uadmin
getdev b ips: No such device (error 19)
v dynamic linker: dlvr_audit: Cannot open /dev/zero for file
/lib/libprot.so.1
You can ignore the first message; if the second message appears, however, you
must press Enter when prompted to continue the installation.
5. Keep the IBM ServeRAID Device Drivers for SCO Operating Systems -
UnixWare HBA and OpenServer BTLD diskette available. You will need it to
configure the device driver into the link kit.
38
IBM
®
Netfinity
®
User’s Reference: ServeRAID
™
-4H Ultra160 SCSI Controller