IBM Netfinity 7100, Руководство пользователя

Страница: 101 / 200

Chapter 6. Installing options
87
To install an additional microprocessor kit:
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http:\\www.ibm.com
1. Review “Before you begin” on page 66.
2. Turn off the server and all attached devices. Disconnect all external cables and
power cords and remove the top cover.
3. Pull up the two pop rivets on the processor housing cover and remove the cover
from the processor housing.
4. Determine the slots where you will install the microprocessor and VRM.
5. Remove the terminator card from the microprocessor connector.
6. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to any
unpainted metal surface on the server; then, remove the microprocessor from
the package.
b. Hold the microprocessor by the open latches, and center the microprocessor
over the microprocessor connector.
Attention: Make sure the microprocessor is oriented and aligned correctly
before you try to close the latches.
c. Carefully close the latches to seat the microprocessor in the connector.
d. Store the terminator card in a safe place in the static-protective package that
your new microprocessor comes in; you will need to install it again if you
ever remove the microprocessor.
7. Install the voltage regulator module (VRM).
a. Center the VRM over the connector. Make sure that the VRM is oriented and
aligned correctly.
Pop rivets
Terminator card
VRM
Processor housing
cover