Controls and Indicators
.6/
Power-on switch: Use this switch to turn on your server, or to return the
server to
Standby mode (power is present but the server is not turned on).
Important
After you plug the server power cord into an outlet, wait 20 seconds
before pressing the power switch. (During this time, the
system-management processor is initializing and the power-on switch
does not respond.)
6
CAUTION:
The Power-On button on the front of the server does not turn off
the electrical current supplied to the server. The server also
might have more than one power cord. To remove all electrical
current from the server, ensure that all power cords are
disconnected from the power source.
The automatic restart feature, which enables the server to restart following a
momentary power loss, means that the server is never completely turned off.
Do not set the server to the Standby mode if any drive in-use light is on. This
might damage the information stored on a hard disk drive or on a diskette. A
Power-On Switch protector, which prevents the Power-On Switch from being
pushed accidentally, is shipped with the server.
To toggle the server between Standby mode and actively running, press and
release the Power-On Switch.
.7/
Side-Cover Release Lever: Use this lever to release the left-side cover.
.8/
CD-ROM Drive In-Use Light: This light comes on when the CD-ROM drive
is accessed.
.9/
Operator LED Panel This panel contains LEDs that light to indicate
conditions on the server, such as power on or a system error (see “Status
Indicators” on page 9).
8
Netfinity 5000 Server Hardware Information and Procedures
