IBM LS21 - BladeCenter - 7971, Руководство по обслуживанию

Страница: 88 / 130

Removing the bezel assembly
To remove the bezel assembly, complete the following steps.
Note: The following illustration shows how to remove the bezel assembly from the
blade server; removing the bezel assembly from the MPE unit is similar.
Bezel-assembly
release (both sides)
Bezel assembly
Control-panel
connector
Control-panel
cable
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 63.
2. Open the blade server cover (see “Removing the blade server cover” on page
68).
3. If you are removing the bezel assembly from the blade server and an MPE unit
is installed, remove the MPE unit (see “Removing an expansion unit” on page
70).
4. Press the bezel-assembly release on each side of the blade server and pull the
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
5. If you are removing the blade-server bezel assembly, disconnect the
control-panel cable from the control-panel connector.
6. Pull the bezel assembly away from the blade server.
7. If you are instructed to return the bezel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you; otherwise, store the bezel assembly in a safe place.
72
BladeCenter LS21 Type 7971 and LS41 Type 7972: Problem Determination and Service Guide