IBM LS21 - BladeCenter - 7971, Руководство по обслуживанию

Страница: 82 / 130

Installing the blade server in a BladeCenter unit
To install a blade server in a BladeCenter unit, complete the following steps. The
appearance of your BladeCenter unit might be different, see the documentation for
your BladeCenter unit for additional information.
Release handles
(open)
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
1. Make sure that the release handles on the blade server are in the open position
(perpendicular to the blade server).
2. If you installed a blade filler or another blade server in the bay from which you
removed the blade server, remove it from the bay.
Attention: You must install the blade server in the same blade bay from which
you removed it. Some blade server configuration information and update options
are established according to bay number. Reinstalling a blade server into a
different blade bay from the one from which it was removed could have
unintended consequences, and you might have to reconfigure the blade server.
3. Slide the blade server into the blade bay from which you removed it until it
stops.
4. Push the release handles on the front of the blade server to the closed position.
5. Turn on the blade server (see “Turning on the blade server” on page 6).
6. Make sure that the power-on LED on the blade server control panel is lit
continuously, indicating that the blade server is receiving power and is turned
on.
66
BladeCenter LS21 Type 7971 and LS41 Type 7972: Problem Determination and Service Guide