IBM LS21 - BladeCenter - 7971, Руководство по обслуживанию

Страница: 85 / 130

Installing the blade server cover
To install the blade server cover, complete the following steps.
Note: The following illustration shows how to install the cover on a single-width
model blade server; installing the cover on a double-width model blade server is
similar.
Blade-cover
release
Blade-cover
release
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Attention: You cannot insert the blade server into the BladeCenter unit until the
cover is installed and closed. Do not attempt to override this protection.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 63.
2. Lower the cover so that the slots at the rear slide down onto the pins at the rear
of the blade server. Before closing the cover, check that all components are
installed and seated correctly and that you have not left loose tools or parts
inside the blade server.
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 66).
Chapter 4. Removing and replacing blade server components
69