IBM IntelliStation Z Pro 6221, Руководство по техническому обслуживанию аппаратной части

Страница: 80 / 168

5. Grasp the main portion of the bracket and press in on the tab located on the
bottom of the bracket upward slightly to release the bracket; then, pivot the
lower portion away from the chassis and disengage the two notches at the top
until the component detaches.
To install the adapter retainer, reverse the previous steps.
IEEE 1394 (FireWire) adapter
Note: Read “Installation guidelines” on page 35, “Handling electrostatic
discharge-sensitive devices” on page 120, and the safety notices at “Safety
information” on page 117.
Complete the following steps to remove the IEEE 1394 (FireWire) adapter:
1. Turn off the computer and attached devices; then, disconnect all power cords
and external cables.
2. Remove the cover, support bracket and baffle (see“Removing the side cover” on
page 39 and “Removing and installing the support bracket” on page 42).
3. Remove any adapters that impede access to the IEEE 1394 adapter.
4. Disconnect the cables on the adapter.
5. Disengage the two retaining clips securing the adapter.
6. Gently grasp the IEEE 1394 (FireWire) adapter and pull it until it comes loose
from the adapter slot.
7. Gently pull up on the IEEE 1394 (FireWire) adapter until it disengages from the
plastic stand-offs. If the stand-offs come away from the system board with the
adapter, gently pull them out of the adapter and push them back into their
apertures on the system board.
Note: You can also gently pinch the top of each standoff using pliers and then
pull the adapter away.
Complete the following steps to install a IEEE 1394 (FireWire) adapter in the
mini-PCI type III slot of the computer:
70
IBM IntelliStation Z Pro Type 6221: Hardware Maintenance Manual