IBM H SERIES RS/6000, Инструкция по установке и обслуживанию

Страница: 123 / 424

Table 3-1 (Page 16 of 38). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
2BA00000 Service processor POST failure 1. Unplug the system power cable and
wait until the system power indicator
remains off and the operator panel is
blank.
2. Plug the system power cable back in
and retry the operation.
3. Replace the service processor card
(Model H50 only).
4. Replace the I/O board. (See notes on
3-1.)
2BA00012 Service processor reports self-test
failure 1. Unplug the system power cable and
wait until the system power indicator
remains off and the operator panel is
blank.
2. Plug the system power cable back in
and retry the operation.
3. Replace the service processor card
(Model H50 only).
4. Replace the I/O board (See notes on
3-1.)
2BA00013 Service processor reports bad
NVRAM CRC 1. If problem persists, replace battery.
2. Replace the I/O board (See notes on
3-1.)
2BA00014 Service processor reports bad
service processor firmware Use service processor firmware diskette to
re-program firmware.
2BA00017 Service processor reports bad or
low battery 1. Replace the battery.
2. Replace the service processor card
(Model H50 only).
3. Replace the I/O board (See notes on
3-1.)
2BA00018 EPOW test failure 1. Replace the service processor (Model
H50 only).
2. Replace the I/O board (See notes on
3-1.)
2BA00019 IRQ13 test failure 1. Replace the I/O board (See notes on
3-1.)
2. Replace the service processor card
(Model H50 only).
2BA00024 Service processor reports bad
Power Controller firmware Use the System Firmware diskette to re-
program the System firmware.
2BA00040 Service processor reports Service
Processor VPD module not present 1. Use the Service Processor Firmware
diskette to re-program the Service
Processor firmware.
2. Replace the Service Processor card
(Model H50 only).
Chapter 3. Error Code to FRU Index
3-17