IBM eServer BladeCenter HS20 Type 8832, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 83 / 158

Note: See “System” on page 94 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
762
(Coprocessor configuration error)
1. Run the Configuration/Setup Utility program.
2. Battery.
3. Microprocessor.
962
(Parallel port configuration error)
1. Run the Configuration/Setup Utility program and verify that the
parallel-port setting is correct.
2. System board.
11XX
(System board serial port 1 or 2 error)
1. Disconnect the external cable on the serial port.
2. Run the Configuration/Setup Utility program.
3. System board.
1162
(Serial port configuration conflicts)
1. Run the Configuration/Setup Utility program and ensure that the
IRQ and I/O port assignments needed by the serial port are
available.
2. If all interrupts are being used by adapters, remove an adapter or
force other adapters to share an interrupt.
1301
(I2C cable to operator information panel
not found)
1. Cable
2. Operator information card
3. Power switch assembly
4. System board
1302
(I2C cable from system board to power-on
and reset switches not found)
1. Cable
2. Power switch assembly
3. System board
1303
(I2C cable from system board to power
backplane not found)
1. Cable
2. Power supply
3. System board
1304
(I2C cable to diagnostic LED board not
found)
1. Power switch assembly
2. System board
1762
(Hard disk configuration error)
1. Hard disk drive.
2. Hard disk drive cables.
3. Run the Configuration/Setup Utility program.
4. SCSI storage expansion unit.
5. System board.
178X
(Fixed disk error)
1. Hard disk drive cables.
2. Run diagnostics.
3. Hard disk drive.
4. System board.
1800
(No more hardware interrupt available for
PCI adapter)
1. Run Configuration/Setup to verify that the interrupt resource
settings are correct.
2. Failing adapter (if installed).
3. System board.
Chapter 8. Symptom-to-FRU index
73