IBM BladeCenter HS20 Type 8843, Инструкция по установке и эксплуатации

Страница: 35 / 112

3. Pull the blade server out of the bay. Spring-loaded doors further back in the bay
move into place to cover the bay temporarily.
4. Place either a filler blade or another blade in the bay within 1 minute. The
recessed spring-loaded doors will move out of the way as you insert the blade
or filler blade.
Opening the blade server cover
The following illustration shows how to open the cover on a blade server.
Blade-cover
release (both sides)
To open the blade server cover, complete the following steps:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 20 for instructions).
3. Carefully lay the blade server down on a flat, non-conductive surface, with the
cover side up.
4. Press the blade-cover release on each side of the blade server and lift the
cover open, as shown in the illustration.
5. Lay the cover flat, or lift it from the blade server and store for future use.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Chapter 3. Installing options
21