IBM BladeCenter HS20 Type 8843, Инструкция по установке и эксплуатации

Страница: 41 / 112

The following illustration shows how to install the second microprocessor on the
system board for the blade server.
Heat sink filler
Heat sink
Microprocessor
Microprocessor
locking lever
To install an additional microprocessor, complete the following steps:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from
the BladeCenter unit” on page 20 for instructions.
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see “Opening the blade server cover” on page
21 for instructions).
5. Remove the bezel assembly (see “Removing the blade server bezel assembly”
on page 22 for instructions).
6. Locate the microprocessor socket on the system board.
7. Unlatch and remove the heat-sink filler.
8. Install the microprocessor:
a. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if one is present.
b. Touch the static-protective package that contains the new microprocessor
to any unpainted metal surface on the blade server or any unpainted metal
surface on any other grounded rack component in the rack you are
installing the microprocessor in for at least 2 seconds; then, remove the
microprocessor from the package.
Attention: Do not use any tools or sharp objects to lift the locking lever
on the microprocessor socket. Doing so might result in permanent damage
to the system board.
c. Rotate the locking lever on the microprocessor socket from its closed and
locked position until it stops or clicks in the fully open position
(approximately a 135° angle), as shown.
Attention: You must make sure that the locking lever on the
microprocessor socket is in the fully open position before you insert the
microprocessor in the socket. Failure to do so might result in permanent
damage to the microprocessor, microprocessor socket, or a system board.
Chapter 3. Installing options
27