IBM 8265 Nways ATM Switch, Руководство по установке

Страница: 59 / 102

Chapter 7. Completing the Installation
This chapter describes the following:
Ÿ
Checking that you have installed all required components.
Ÿ
Powering on the 8265.
Ÿ
Verifying that components are operating correctly.
Checking Your Installation
Use the following table to check that you have installed all the required components. Refer to the relevant
page if you have omitted a component.
Table 7 lists the items to have been installed.
Table 7. Installation Steps
Item Required/Optional See
Cable Management Tray optional page 8
DC power supply power cord preparation required if DC power used page 23
AC or DC power supplies 2 minimum required page 20 or 21
Power supply bay grille optional page 26
Control Point and Switch module(s). 1 minimum required page 29
PCMCIA card for CPSW module required page 30
Memory upgrade for CPSW module optional page 31
Controller module(s) 1 minimum required only when
standard CPSW used
page 33
Configuration console required page 39
Note: You should also have switched each power supply unit to ON.

Copyright IBM Corp. 1994, 1998
45