IBM 8237, Инструкция по установке и эксплуатации

Страница: 128 / 166

Appendix B. The IBM 8237 Management Information Base
B-11
basicSegmentIpAddr
IpAddress,
basicSegmentNetMask
IpAddress,
basicSegmentGateway
IpAddress,
basicSegmentSlipAddr
IpAddress,
basicSegmentReset
INTEGER,
basicSegmentIpxFrame
INTEGER,
basicSegmentIntIpxNet
OCTET STRING,
basicSegmentName
DisplayString
}
basicSegmentIndex OBJECT-TYPE
SYNTAX INTEGER (1..3)
ACCESS read-only
STATUS mandatory
DESCRIPTION "Backplane segment number."
::= { basicSegmentEntry 1 }
basicSegmentProtocol OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-write
STATUS mandatory
DESCRIPTION "For protocol stack definition :
bit 0: IP protocol stack
0: disabled; 1: enabled
bit 1: IPX protocol stack
0: disabled; 1: enabled
bit 2: SNMP over Ethernet
0: disabled; 1: enabled"
::= { basicSegmentEntry 2 }
basicSegmentIpAddr OBJECT-TYPE
SYNTAX IpAddress
ACCESS read-write
STATUS mandatory
DESCRIPTION "IP address of this segment.
The corresponding definition in each segment
of the 8237 system. Because the IBM 8237 is a
multi-home host (A device has multiple
interfaces without routing capability), each
segment of the 8237 system has its own
interface parameters, such as the IP address.
When the agent switches to another segment,
the interface parameters are changed. The
interface parameters are defined in the
following variables."
::= { basicSegmentEntry 3 }
basicSegmentNetMask OBJECT-TYPE
SYNTAX IpAddress
ACCESS read-write
STATUS mandatory
DESCRIPTION "IP netmask of this segment."
::= { basicSegmentEntry 4 }
basicSegmentGateway OBJECT-TYPE
SYNTAX IpAddress
ACCESS read-write
STATUS mandatory
DESCRIPTION "Preferred gateway of this segment."