IBM 7199-92X, Инструкция по установке и эксплуатации

Страница: 64 / 82

2. Press the blue button and the lever pops open. Figure 17 illustrates the
following steps.
a. Pull the lever towards you to pull out the hard disk drive module.
b. Pull the failed module out of the chassis.
3. Set aside the failed module.
Attention: Ensure that the gold connectors at the rear of the module do not
come into contact with your hands or with the packing material as you unpack
the replacement module. Avoid damaging the gold connectors against the
chassis as you insert the replacement module.
4.
Unpack the replacement module.
5. Carefully align the module, and insert into the chassis.
6.
Push the lever forward until you hear the release latch click in place.
7. Turn on the appliance by pressing the power button located on the front of the
chassis.
8. Verify that the power LED is illuminated.
After replacing the module, you can verify that the new module is working if:
v For the Type 7199, the amber LED on the hard disk drive module is not
illuminated.
v
The fault LED light on the front of the chassis is not illuminated.
After verifying that the replacement module is working, return the part to IBM.
For details, see “Returning an appliance or part” on page 36.