Handling static-sensitive devices
Read the following guidelines before handing static-sensitive devices.
Attention:
Static electricity can damage the Type 7199 chassis and other electronic
devices. To avoid damage, keep static-sensitive devices in their static-protective
packages until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v
The use of a grounding system is recommended. For example, wear an
electrostatic-discharge wrist strap, if one is available.
v
Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v
While the device is still in its static-protective package, touch it to an unpainted
metal part of the Type 7199 chassis or rack for at least 2 seconds. This drains
static electricity from the package and from your body.
v
Remove the device from its package and install it immediately without setting
down the device. If it is necessary to set down the device, put it back into its
static-protective package.
v
Take additional care when you handle devices during cold weather. Heating
reduces indoor humidity and increases static electricity.
Returning an appliance or part
If you are instructed to return an appliance or component, follow all packaging
instructions and use any of the packaging materials that is provided for shipping.
Note:
You may be charged for the replacement appliance or part if IBM does not
receive the defective appliance or part within a reasonable timeframe.
7199 parts listing
The Type 7199 appliance includes Tier 1 CRU replaceable parts and FRU parts.
For information about the terms of warranty, see the
IBM Statement of Limited
Warranty
document that is provided with the appliance.
For information about obtaining service or assistance, see “Getting help and
technical assistance,” on page 55.
CRU parts listing
The Ethernet modules, hard disk drive modules, fan modules and power supply
modules are CRU parts. Figure 14 on page 37 shows the CRU parts on the front
and the back of the Type 7199 appliance.
36
WebSphere DataPower XC10 Appliance: Type 7199-92X: Installation and User's Guide
Содержание 7199-92X
